What is this??

1 - 1 of 1 Posts

mike zielinski

Registered

Joined Aug 3, 2007

15 Posts

Discussion Starter • #1 • Aug 29, 2007 (Edited)

On my new '89 Spider Veloce, on the lower console panel where the power window buttons are, to the left of the rear fog light buttons there is something that looks like a small lens. Does anyone know its purpose?

Is mine the only Veloce that has this strange little lens, if that is what it is?

1 - 1 of 1 Posts

Join the discussion

Recommended Reading

Wiring diagram

Electrical, Chassis & Lighting

Hello everyone, I am new here and in need of a wiring diagram for a 1979 Spider Veloce. I was given this car in boxes, the previous owner thought he was going to restore it. Car is back together except for the interior. He tore the dash and console out and did not mark anything. I have some of...
- 3
- 360
- K
  Kalman1968 · updated 2 d ago
LHD vs RHD headlamps....

Electrical, Chassis & Lighting

Hi All, I really should know this, but I don't. Can anyone tell me how to identify (visually) LHD vs RHD headlamps ... ( mine is a 78 spider) many thanks Clive
- 3
- 122
- S
  Spiderworks · updated 4 d ago
164 Alternator charging problem

Electrical, Chassis & Lighting

I parked my 164 a couple months ago because it was past due for Timing belt replacement. When I went to start it to bring it in the garage to replace the timing belt it was running rough, and surging. So when I replaced the timing belt i also did a full tune up. I replaced the distributor cap...
- 2
- 208
- Roadster78 · updated 4 d ago
Instrument lighting 88 Veloce

Electrical, Chassis & Lighting

Probably a silly question but does the instrument lighting only work with ignition . Been all over PapaJam's excellent wiring diagrams but answer isn't obvious to me. I suspect the Rheostat control is not passing current but haven't yet tested it.
- 5
- 67
- B
  bejem17 · updated 5 d ago
Should I get a new wiring harness / loom?

Electrical, Chassis & Lighting

I need some advice. I am a mechanical guy, but pretty unskilled with auto electrics. And that is the basis of the question I have. I am doing a bare metal restoration of a 74 GTV (US with AC) and need to decide if I should keep the loom I have or get one of the new ones available on the...
- 12
- 235
- crackie · updated 10 d ago