Valve installation.
Join the discussion
Recommended Reading
-
Camshaft Identification
Engine Repair, Diagnostics & RebuildingAlfisti, Cleaning out the garage and found a tub with some camshafts - some with stampings and markings and some not. I have done some quick measurements and have listed what I think the lift is next to the cam. Keep in mind, very quick measurements. I have looked through old Shankle, Alfa...- 5
- 426
-
Nor Cal Dynotuner Wanted
Engine Repair, Diagnostics & RebuildingI am up in Magalia (above Chico, 100 miles north of Sacramento) I could really use a weber capable dyno tuner to sort out an abonormale build with 4 DCOE carbs. It runs very nice at low rpms up to 3500, has a vibration/stutter at around 3800 rpm to 4000 then smooths out to 5000. I am not...- 6
- 82
-
Neil Martin · updated
-
Low Oil Pressure Sender Tap Size
Engine Repair, Diagnostics & RebuildingWhat is the tap/fitting connection size for the low oil pressure sender on a 2L engine block? I plan to check the oil pressure with a mechanical gauge which has a 1/8" npt fitting. I'll need an adaptor to connect it I'm sure. TIA Ken- 4
- 100
-
bellagt · updated
-
Factory service manual for Giulietta 2015
Engine Repair, Diagnostics & RebuildingHi Does anyone knows where can I get / purchase a Factory service manual for Giulietta 2015 in English ? All I find in Ebay and other websites is the Italian manual- 3
- 70
-
m3csl · updated
-
HELP IDENTIFYING 1600 VENOLIA PISTONS
Engine Repair, Diagnostics & RebuildingCan anyone help me with identifying these Venolia pistons. They are stamped inside Venolia and RT>. They are 78.9 mm across the shirts so are for a 79mm bore. The dome rises 20.6 mm above the deck line with large valve pockets. 3 rings An old Shankle Automotive Engineering catalogue...- 4
- 395
-
kengta · updated
Join now to ask and comment!