Transmission copper washers what type
1 - 2 of 2 Posts
Joined
·
850 Posts
I use the same ones as for the oil drain. I would use sealing (solid) washer. Either one would be ok, crush washers are one time use only. Outside diameter is smaller than factory oil washer. Everything I have bought at Advance and Pep Boys has worked fine for both.
1 - 2 of 2 Posts
Join the discussion
Recommended Reading
-
S2 1971 spider: what is this?
Spider - 105 & 115 Series (1966-1994)Hi all once again, can someone please tell me what this is? It’s one the RF gender, between the SPICA and coil. Four hoses attach to it, two them from the SPICA. When I shake it, there’s a rattle inside, or liquid sloshing inside. Anyone... Bueller? Many thanks, Bob- 10
- 150
-
radojko · updated
-
Chain Tensioner Wedge
Spider - 105 & 115 Series (1966-1994)When I took the head off my 74 Spider, I discovered that the chain tensioner wedge was not in the tensioner. I ordered a new one from Centerline, and I cannot get the assembly to fit into the cylinder with the wedge attached. It hits the front of the cylinder and falls out. I’ve tried every...- 34
- 321
-
The top on my 71 Spider is too tight
Spider - 105 & 115 Series (1966-1994)I bought a 71 Spider over the winter. I recently attempted to put the top up, but can't get it to reach other than to just barely engage the clamps, leaving a good inch or two to go. I'm told leaving it in the sun helps and then "applying some muscle". The question is where exactly does one...- 12
- 145
-
Slave cylinder hissing?
Spider - 105 & 115 Series (1966-1994)Hello! 1987 Alfa spider graduate. I’m having problems with my clutch not disengaging. I can have the car running and pump the clutch fine with pressure but a mile down the road and the clutch pedal is stuck matted to the floor but releases. Any ideas? TIA Clayton Sent from my iPhone using...- 20
- 253
-
speedhunter · updated
-
73 spider stuck seat rails
Spider - 105 & 115 Series (1966-1994)I need to remove my passenger seat but to acsess the back bolts I need to slide the seat forward but the seat rail is stuck. The unlocking mechanism seems like it's working but I'm not 100% sure on that. The seat is all the way back so trying the hammer the rail forwards isn't possible. I've...- 27
- 243
-
New_Guy_46 · updated
Join now to ask and comment!