Alfa Romeo Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
54 Posts
Discussion Starter · #1 ·
So I have been wanting to raise the front of my Milano because it was lowered when I purchased it, and at this point I think it is too low.

I attempted to raise it following these instructions; (Alfa Romeo Suspension Technical Article) which I found searching these forums. Well the outcome was less then desired so I am trying again, but at this point I just want the front stock.

Using the work manuals at Craig's Place, I see how the markings on the rear of the torsion bar and rear support line up. But the manual seems to avoid the markings on the lower control arm up front.

Does anyone know how the markings on the front line up for a stock setup?
 
1 - 1 of 1 Posts
Top