[83spyderman]

Any tricks to this? It squeals like a <insert favorite squealing creature here>, and I can't seem to find a good place to get a pry bar in (i.e. NOT against the pulley!) to get it tightened. Car has a standard issue 2.5 V6...

Has anyone had more success approaching from below vs. above?
-Dave

 

[83spyderman]

Belt no longer squeaking (just needed a prybar in the right spot)... New belt went on about 8 mos back; likely this one broken in over time).
Appreciate all the comments on here. In the "one thing leads to another" dept, driveshaft will need a rebuild (front donut is cracked), and exhaust will get replaced. This was confirmed once papajam took a peek underneath.
I was hoping the occasional burnt rubber smell was from the belt, but no such luck.
Dave