[rjpgearz]

I'm in need of a Thermostatic Actuator for Spica F/I (shown below) that fits 74 Spider. In good condition; the bulb-end extended tip of the actuator (goes in pump) should measure 23 to 25 mm from end of tip to mounting flange.

Thanks - appreciate the help.

r~

 

[stefmiesterb]

New TA

I have a new one & a used one ....pm me for details.

 

[gprocket]

You might want to check out this thread: http://www.alfabb.com/bb/forums/carburetors-fuel-injection-air-intake/394353-force-applied-spica-ta.html

If you're not in a huge hurry, we're getting close to having something workable.

 

[rjpgearz]

Cost of new TA?

 

[brianthegood]

TA cost

Wes Ingram charges $325 and a core charge of $100

 

[Andrew]

$325 from Wes gets you a new tube. $245 gets you a rebuild on an existing tube.
Andrew

 

[gprocket]

Cost of new TA?

We don't all the costs together but we anticipate that the eTA will be substantially less than a rebuilt factory TA.

 

[Andrew]

I wonder about your dimensions above; you say 23-25, but 27+mm is normally the extension you need. Some rebuilts come out longer than that, but you can put shims in to bring them down to spec when installed.

Andrew