Alfa Romeo Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
603 Posts
Except for the rusted out areas, it looks to me as if the rest of the floor pan is pretty solid. If it was me, I'd just cut out the rust and weld in some patches. It will be a lot easier than cutting out the whole floor. I just went through this on my Spider, and I was a little surprised at what a PIA job it was to cut and match larger panels for the floor pan.

Best regards,
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top