Alfa Romeo Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
461 Posts
Discussion Starter · #1 ·
Hello,

I inherited a 115.01 that was disassembled. I am putting it back together.

Does the center console wire loom route behind the heater then out to the connector on the console or does it routed to the left of the heater?

Just test fitting the interior right now and it looks like the loom could go either way. How was this wire loom route when the car came from the factory?

Thank you.

Bob
 

·
Registered
Joined
·
397 Posts
Bob,

I removed the ash tray, took a peek and can see that the wiring harness passes to the right (passenger) side of the gear shift. Further back, the harness comes down between the glove box and heater, travels between the sound deadener material and carpet finally entering the console area on the right side. Hope this helps you.


Doug
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top