Researching, turbo V6 builds? | Alfa Romeo Forums

1 - 1 of 1 Posts

horsewidower

·

Premium Member

Joined Jun 15, 2006

·

2,790 Posts

Discussion Starter • #1 • Apr 1, 2015

I'm trying to convince my partners on our Bonneville project to use a turbocharged Alfa V6 in 2016. It would fit very cleanly in our little engine bay ('72 Datsun pickup), plus it would allow me to experiment with the Alfa V6 in an engine performance program.

Please let me know where to look for any relevant information.

Thanks
Bob

1 - 1 of 1 Posts

Recommended Reading

Cam caps on a 2 liter GTV engine

Engine Repair, Diagnostics & Rebuilding

I’m about the remove the head as part of a light rebuild. I have the Brooklands owners workshop manual as s guide, and also the Cardisc for the GTV. Question: is there a default correct orientation and position for each cam cap? My caps are stamped 1 thru 6. They are positioned in the order...
- 2
- 79
- bfeng · updated 11 h ago
'86 Alfa Spider Quadrofoglio over heating

Engine Repair, Diagnostics & Rebuilding

Greetings! New member, new owner (well my wife anyway) We recently purchased an '86 Spider Quadrofoglio from the original owner, about 156k miles and all records included. It's in relatively great shape mechanically. However, recently while driving it began to over heat. Light came on sitting...
- 6
- 275
- S
  sdcombat · updated 23 h ago
oil pump and distributor alignment issue

Engine Repair, Diagnostics & Rebuilding

Hi I have fully rebuilt my 1750 engine and set up the oil pump as per the book with the slot at the top of the shaft facing from front to back of engine when at top dead centre. the book shows the distributor rotor should point to the front of the engine. unfortunately the rotor is at 90degrees...
- 9
- 208
- I
  ITALCAROZ · updated 1 d ago
Spider Catches Rat

Engine Repair, Diagnostics & Rebuilding

ok
- 7
- 221
- G
  Gary Ellis · updated 1 d ago
Advance timing with Performance cams

Engine Repair, Diagnostics & Rebuilding

Hi, I have installed Fast Road cams from Alfaholics on my 1973 GT veloce 2000. I have to say they really help the engine to rev better. When I started to tune ignition timing (I got a 123tune fully programable unit), I got very good torque at low to mid RPM (1200 to 3000), but Advance is way...
- 4
- 158
- A
  Aubryl · updated 2 d ago