Alfa Romeo Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
336 Posts
Discussion Starter #1
Can I just confirm that the rear brake pipes travel along the axle, then through the first hole on the bump braket (!) annd NOT through the second one?

I have trawled this site and looked at photos and this appears to be what is done but the 2nd hole is making me wonder if it should also travel through that on its way to the caliper!

Matt
 

·
Registered
Joined
·
336 Posts
Discussion Starter #3
Yes - but I would be tempted to put some plastic/tube around the pipe where it meets the hole - as per original :) -

It all makes sense when looking at the photo that if I used the other hole, the pipe would be too close to the straps. I suppose the brackets are made non handed (ie 4 for per car) then welded on.

Whille I look at this photo, were backplates plated or painted?

Matt
 

·
Premium Member
Joined
·
512 Posts
And so I did..

I did add some rubber tubing before it went under the car. Also where it goes over the diff.

I reckon they were plated.
 
1 - 5 of 5 Posts
Top