Joined
·
451 Posts
email me for info on anything you might need. this car will be completely dissasembled in the next couple of weeks due to rust. [email protected] thanx reyy
parting out 78 sprint veloce
1 - 7 of 7 Posts
Joined
·
148 Posts
Since the thread has been bumped up, I'd like to say thanks again for the door handles.
cheers,
scott
cheers,
scott
1 - 7 of 7 Posts
Join the discussion
Recommended Reading
-
Bringing back 7840
Alfetta & GTV6 (1972-1986)Back in January I added an 86 GTV6 to the fleet. I've been doing a lot of reading since then. It was last registered in 2006, it also had a bunch of work to it in the spring of 2019 to try and bring it up to roadworthy standards which sure seemed to add up to a really big bill for the previous...- 41
- 2K
-
Fuel pump noise after hard running
Alfetta & GTV6 (1972-1986)Hey there, So had the Sedan out last Saturday for an aggressive mountain drive. Performed great! However, when restarting after taking a break after some heavy running I hear a lot of fuel pump noise. On the way down we did about 16 miles wihtout stopping of very tight canyon roads and...- 11
- 299
-
GTV6 front wheel bearing adjustment
Alfetta & GTV6 (1972-1986)I just replaced the passenger / right front bearings on mt GTV6 but I have a question about adjusting them. I followed the book procedure - tighten to 20-24 NM spin, loosen, retighten to 5-10 Nm, loosen 90 degrees then insert cotter pin. I even went an extra 1/8" turn for good measure, but I...- 9
- 117
-
archeologist · updated
-
Options for front inner splash guards?
Alfetta & GTV6 (1972-1986)Instead of plunking down a couple hundred bucks for OEM-ish replacements, has anyone ever considered nabbing some modern plastic wheel well liner from the boneyard, using the rusted out original as a template, and just cutting a new never-rust replacement? Better than consider it, has anyone...- 4
- 605
-
chairmankaga · updated
-
Alfetta GT Dedion modifacations
Alfetta & GTV6 (1972-1986)I have the above on the bench with plans to cut, bend and weld. I purchased the RSR adjustable springs, perches and watts linkage to replace the OEM parts., These parts are of the highest quality. How do determine 12 o'clock next to the hubs to know where top is. Thoughts on degrees negative for...- 6
- 434
Join now to ask and comment!