Alfa Romeo Forums banner

1 - 3 of 3 Posts

·
Premium Member
Joined
·
1,965 Posts
Discussion Starter #1
I'm in the process of adjusting my doors to get them to open and close nicely. The driver door needed to be slammed to get it to engage and then would drop down when opening. Now its perfect. The passenger door was always the better of the two, but it too needed a decent shove to overcome some binding that would keep the door from engaging the striker, and then spring the door open when I would open the door. After playing with all the hardware in the jamb, I finally noticed the binding is caused by the vent wing window. It leans too far inward at the top and binds against the pillar. I know the vent window can be adjusted up and down and a little forward and back, but is there a way of tilting the top inward and outward (in my case outward). I've tried to gently pull it outward with no luck and don't want to break it. But it definetely needs to be tilted out. Other than this, the doors look good (fairly even gaps all around and flush with the quarter panels and fenders). Thanks
 

·
Premium Member
Joined
·
1,965 Posts
Discussion Starter #3
Thanks Eric. That should help quite a bit. Thanks again.:)
 
1 - 3 of 3 Posts
Top