Alfa Romeo Forums banner
1 - 3 of 3 Posts

·
Premium Member
Joined
·
1,137 Posts
Discussion Starter · #1 ·
The yellow spring set from Centerline helped a lot with body roll, but I failed to take into account the difference in spring length and now the rear of my QV is waaay too low (3”?). Spacers are available, but won’t give me the lift I need. Also, I discarded the old springs 🙁

Suggestions welcome.
Wheel Tire Automotive parking light Car Vehicle
 

·
Premium Member
Joined
·
1,137 Posts
Discussion Starter · #5 ·
yup... a butt dragger,,,1/2 spacer will raise the rear 1 inch..i think i have a few spacers i can send you
I appreciate your generous offer, but I’m confused.:unsure:

As genericwood observed, how can a 1/2” spacer raise the rear end 1”?

To further complicate matters, Centerline says their 1” spacers ”…raise the rear 1”-1.5”…”.

Why isn’t the ratio 1:1? :unsure:

Apparently I need to be enlightened about spring rates.

Also, I fear 1” isn’t going to solve my problem.:(
 

·
Premium Member
Joined
·
1,137 Posts
Discussion Starter · #7 ·
All four changed. One more thing to check when I get underneath…
 
1 - 3 of 3 Posts
Top