Head Gasket Spec

1 - 1 of 1 Posts

Alfa-Born

Registered

Joined May 27, 2007

136 Posts

Discussion Starter • #1 • Aug 12, 2007

how thick is the original head Gasket on the Alfa Spider, l j-tronic 1985???
I have found a nice company that would do the gasket in copper for me, but i need to give him some thickness. I am trying to reduce my compression ratio.

Any help??

1 - 1 of 1 Posts

Join the discussion

Recommended Reading

Nor Cal Dynotuner Wanted

Engine Repair, Diagnostics & Rebuilding

I am up in Magalia (above Chico, 100 miles north of Sacramento) I could really use a weber capable dyno tuner to sort out an abonormale build with 4 DCOE carbs. It runs very nice at low rpms up to 3500, has a vibration/stutter at around 3800 rpm to 4000 then smooths out to 5000. I am not...
- 3
- 43
- Neil Martin · updated 1 h ago
Low Oil Pressure Sender Tap Size

Engine Repair, Diagnostics & Rebuilding

What is the tap/fitting connection size for the low oil pressure sender on a 2L engine block? I plan to check the oil pressure with a mechanical gauge which has a 1/8" npt fitting. I'll need an adaptor to connect it I'm sure. TIA Ken
- 4
- 89
- bellagt · updated 21 h ago
Factory service manual for Giulietta 2015

Engine Repair, Diagnostics & Rebuilding

Hi Does anyone knows where can I get / purchase a Factory service manual for Giulietta 2015 in English ? All I find in Ebay and other websites is the Italian manual
- 3
- 63
- m3csl · updated 2 d ago
HELP IDENTIFYING 1600 VENOLIA PISTONS

Engine Repair, Diagnostics & Rebuilding

Can anyone help me with identifying these Venolia pistons. They are stamped inside Venolia and RT>. They are 78.9 mm across the shirts so are for a 79mm bore. The dome rises 20.6 mm above the deck line with large valve pockets. 3 rings An old Shankle Automotive Engineering catalogue...
- 4
- 394
- kengta · updated 3 d ago
Ar 118.284s camshaft question

Engine Repair, Diagnostics & Rebuilding

I have a Ar 118.284s camshaft here. I suspect it to be a Colombo bariani, but cannot find any data on it. Anyone? Measurement tells me the lift is 11,3mm I have another camshaft, looks like a c&b too, but no markings. Measures a 10,1mm.
- 4
- 169
- H
  HAAK38 · updated 5 d ago