[alfasteve]

Looking for a good, uncracked used or NOS rubber section of the fuel filler section of an `85 GTV-6. Or if anyone knows where to source one, that would be much appreciated, as well. Thanks!

 

[bibendum59]

There is another post on here that mentioned a supplier that carries a generic part that fits. I think it was Fillerneck.com or something similar.

 

[jshinbot]

I just replaced mine in my Milano (maybe similar?) with a "Gates 24713" (available everywhere). Had to chop off a little on the ends, but it fits perfectly.

 

[vintagemilano]

You have a few options. The filler neck is close to 2.25" and the gas tank inlet is close to 2". Three options, in no particular order.

A) 2" TO 2-1/4" I.D. Fuel Filler Neck Hose Reducing Adapter GH2225

B) 2-1/4" to 2" Fuel Fill Hose End ID Reducer. 57mm to 51mm ID

C) Basically make your own B option from above, My little project