Alfa Romeo Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
76 Posts
Discussion Starter #1
Hey guys,I want to change my stock gear knob with an aftermarket weighted one but most of the items I'm looking at have an M10 x 1.5 thread pattern.
does any one have any Idea about the thread pattern of the milano gear lever?
should I end up using a universal knob? ( with the rubber bits inside )
I'd appreciate your opinions.
 

·
But Mad North-Northwest
Joined
·
11,124 Posts
Unless things were different in Europe, the stock knob isn't threaded, it's press-on.

You want to get one of the aftermarket knobs with three set screws.
 

·
Registered
Joined
·
76 Posts
Discussion Starter #3
Unless things were different in Europe, the stock knob isn't threaded, it's press-on.

You want to get one of the aftermarket knobs with three set screws.
So in other words I'm gonna need a universal fitting knob; right?
 

·
But Mad North-Northwest
Joined
·
11,124 Posts
Basically yes. Any of the ones for unthreaded shafts.
 

·
Registered
Joined
·
76 Posts
Discussion Starter #6
Hey does anyone know what's the diameter of the gear lever? I've found a knob but the inlet size is 13 milimeters and I don't think it comes for bushings for different diameters!
 
1 - 6 of 6 Posts
Top