Alfa Romeo Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
177 Posts
Discussion Starter #1 (Edited)
I am doing a complete restoration of my 1970 stepnose. After cutting out the wheel well, I found that the section behind the right rear wheel has rusted out. When cut out, there was more debris collected between these two panels, than it was in both of the entire sill sections combined. What is the purpose of this panel, other than creating a rust pocket? The opposite side of the car does not have this reinforcement, and rarely rusts out. Both RHD and LHD cars have this section on the same side, so I guess it has something to do with the wheel well/gas tank orientation? Considering leaving the inner section open.

EDIT: Just realized this thread would be better off in the Car Restoration section of the forum
 
1 - 1 of 1 Posts
Top