Alfa Romeo Forums banner
1 - 15 of 15 Posts

·
Registered
Joined
·
5,500 Posts
Discussion Starter · #1 · (Edited)
Wanted for Giulia Super, Altisimo clear lens and/or housing and rubber as in the photo. What ever you may have. Or leads.

The bigest problems are with the right side housing and lens.

Thanks

KEN

Motor vehicle Bumper Automotive exterior Auto part Vehicle
 

·
Registered
Joined
·
6,296 Posts
1653038

1653039

Ken,

I have a NOS Olsa unit and a NOS Altissimo lens. Although the base unit looks similar to yours, I'd have to check that the screw holes align, in case you want both.

Alex.
 

·
Registered
Joined
·
5,500 Posts
Discussion Starter · #3 ·
View attachment 1653038
View attachment 1653039
Ken,

I have a NOS Olsa unit and a NOS Altissimo lens. Although the base unit looks similar to yours, I'd have to check that the screw holes align, in case you want both.

Alex.
View attachment 1653038
View attachment 1653039
Ken,

I have a NOS Olsa unit and a NOS Altissimo lens. Although the base unit looks similar to yours, I'd have to check that the screw holes align, in case you want both.

Alex.
PM Sent
 

·
Registered
Joined
·
5,500 Posts
Discussion Starter · #4 ·
Thanks Alex, Any one else with something to offer.

Ken
 

·
Registered
Joined
·
5,500 Posts
Discussion Starter · #6 ·
Here's a lead, hope it helps...



Bob
Here's a lead, hope it helps...



Bob
Thanks Bob, I have been through the usual UK and EU venders and so far cannot find exact replacement so have to decide on what to change to if I have to go that expensive route of all new units both sides.

Just hoping to luckily find something.

Ken
.
 

·
Registered
Joined
·
5,500 Posts
Discussion Starter · #8 ·
Thanks Thierry. I will have a look.
Ken
 

·
Registered
Joined
·
5,500 Posts
Discussion Starter · #11 ·
BBT still looking
 

·
Registered
Joined
·
5,500 Posts
Discussion Starter · #13 ·
DEA, THANKS FOR POSTING. These are not the same lens pattern as mine. Mine are on a 1969 Super Biscione. What is the original application for these? Are you sure they will fit my housings.

Thanks

ken
 

·
Registered
Joined
·
217 Posts
Ciao Ken, tomorrow I'll give you the part numbers signed on the lenses D and S ( destro e sinistro ) so you can check if correspond to your parts. I think this is the best solution.
Best regards, Luca.
 
1 - 15 of 15 Posts
Top