[Tgood]

I am looking for the plug that goes on the back of the hazard switch to the wire harness, and the brake fluid check button on the center console.

I am also missing all the clamps and hardware for the hard fuel lines from the pump to the intake. I could even use one of the studs from the intake, as only half of the original is left.

While I am at it, a good ta would be nice!

I am in Portland, Oregon so local would sure be nice!

Thanks,

Tom

 

[Tgood]

Just to clarify, here is a picture of the harness plug I hope to get. Well, not a picture of what I need, but a picture of what I have. You can understand why I want to get the correct part in place.



TIA!

 

[papajam]

There's no 'connector' for the hazard switch; just 4 individual wires each with their own female spade connector.

 

[71 alf alfa]

i think a fiat spider has the connecter your looking for if you need one that bad and i have the other bits you need pm me thanks joe t

 

[alfalfa339]

Hi, I have the spica metal line clamps. PM me and I will check where they are. Bob 321-279-0922