New Auto Delta 16 Valve Cylinder head. The head is part machined.
I obtained the head out of the US a few years ago, I think it was made in Europe originally but not sure if it's an original casting or a replica. It's face and top deck are machined and are to the correct measurements. All that's...
Need some small items to finish my intake & throttle body rebuild. Can anyone help with these two sets of items as follows:
1. The retainer, tab lock and nut (though I can source the nut, if need be) that holds on the throttle control mechanism.
2. The throttle cable clamp
I have a set of Campagnolo Turbinas for Alfetta (4x98 bolt pattern). I'll be swapping them out for some Ronal A1s, so I'm considering selling them. They are straight, no curb rash, basically in excellent condition (will post photos when I get the chance). What do you think would be a...
I need 2 velocity stacks for my ACL intake horn assembly. Please see the reference picture. The hole at the base of the cast portion measures slightly over 40mm. Please let me know if you have 2 of these that I could purchase. Thank you!