Alfa Romeo Forums banner

early 164 super 3.0L 24V cranks sensor wanted

943 views 7 replies 4 participants last post by  Alfissimo Int. 
#1 ·
Hi i have a problem with crank sensor but encountering a bigger problem finding a new one can anyone help or have a solution to fit a later type to this engine .
Mick.
 
#2 ·
#4 ·
Just remove old sensor from bracket and insert new sensor into aluminum bracket they are all that way since 1987.
 
#7 ·
I can't say everyone runs into this, but proceed with caution when removing that little Allen head bolt. Mine came out, but it was way over tightened. Without the 3/8 drive Allen head bit that I ran out to buy, I think I likely would have rounded it out with a standard Allen wrench, as well as the long Allen driver with rounded type head. That bit seemed like it started to twist.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top