Alfa Romeo Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
373 Posts
Discussion Starter #1
Car won't start after timing belt and tensioner change. I need some help with diagrams and anything else. Alfisti Steve has been also giving advice and I need to see the following to make sure I test every thing.

RPM/timing sensor?

Coolant temp sensor?

Any other advice is appreciated - it's like it's not getting any spark.
 

·
Premium Member
Joined
·
26,820 Posts
164 RPM/Timing and Coolant Temp Sensor Info

164 RPM/Timing and Coolant Temp Sensor Info

S31 in wiring diagrams is RPM/Timing Sensor and has a 3-wire Bosch connector. It is located next to toothed front crank pulley and has preset air gap of .020" to .050" (.5 to 1.5mm).

S7 in wiring diagrams is Coolant Temp Sensor amd has a 2-wire Bosch connector. It is located in mid thermostat housing at a 45 degree angle under top radiator hose that is attached to thermostat outlet (hidden from view from top of engine). It is not 2-spaded terminal equipped temp gauge and red light sender facing forward next to timing belt cover.

Attached pictures are from 24v shop manual but sensors are in the same location on 12v
models.

http://www.alfabb.com/bb/forums/164-168-1991-1995/50272-164-rpm-timing-coolant-temp-sensor-location-info-etc.html#post440986
 
1 - 2 of 2 Posts
Top