Joined
·
28,754 Posts
P-N start switch is on right side of A/T lever and is adjustable. It also has springy flat blade contacts that have to mate with contacts on side of lever. They can get dirty and loose tension..
Remove rear ash tray, remove console holding screws under ash tray, pull up parking lever, put shifter in L, pull t-handle off shifter. Now slide console rearward and lift up front of console so you can clean and adjust P-N switch. Use some dielectric grease on contacts.
You may have to loosen 13mm adjusting nut on PL cable with 13mm 1/4" drive socket with universal joint anf 6" extension on ratchet to get lever up enough to lift front of console enough.
Be sure you hook back up green light sockets if they pull out of P-R-N-D indicators and cigar lighter if they come out.
Report your successful completion of process.
Remove rear ash tray, remove console holding screws under ash tray, pull up parking lever, put shifter in L, pull t-handle off shifter. Now slide console rearward and lift up front of console so you can clean and adjust P-N switch. Use some dielectric grease on contacts.
You may have to loosen 13mm adjusting nut on PL cable with 13mm 1/4" drive socket with universal joint anf 6" extension on ratchet to get lever up enough to lift front of console enough.
Be sure you hook back up green light sockets if they pull out of P-R-N-D indicators and cigar lighter if they come out.
Report your successful completion of process.
