Alfa Romeo Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
479 Posts
Discussion Starter · #1 ·
I purchased a cast iron two piece Euro exhaust manifold for my Alfetta Sedan.
Here's the problem; it doesn't fit. The motor is on a stand and I cannot get the #1 - #4 portion to line up with the head studs. The smaller #2 - #3 piece slides right on. I at first thought that perhaps I had bent the studs during engine removal but the original manifold slides on just fine. Suggestions?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top