Alfa Romeo Forums banner

1 - 5 of 5 Posts

·
Premium Member
Joined
·
3,927 Posts
Discussion Starter #1 (Edited)
SOLD


I'm selling an original Alfa special tool from the late 50's to early 60's.
This is the tool for removing the valves from Giulietta and Giulia series. This is the first generation of this tool as the support and retainer are specific to these models. The later ones are universal to fit all 4 cly models. Tools are in good shape factory numbers are readable. Chrome platting is peeling in some spots.

The tool numbers are A.3.0103/1, A.3.0103/2 and A.3.0103/6

Can be used on the later 4 cly engines.

Asking $150.00 including shipping. I will ship internationally at my cost.
 

Attachments

·
Premium Member
Joined
·
858 Posts
Is this small enough for a Giulietta 750 head? The valve cups are smaller on 750 engines than on the 101 and later, as I understand. If this will work with my 750 engine, then I will buy it.
 

·
Premium Member
Joined
·
3,927 Posts
Discussion Starter #3
Tom

PM sent
 

·
Premium Member
Joined
·
858 Posts
Jim, This is for a later car, i.e., 101 or 105. The compressor disk is approx. 34 mm, which is too big for the bore of the cam follower in a 750 motor. So, I will pass on this. - Tom
 
1 - 5 of 5 Posts
Top