Alfa Romeo Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
1,088 Posts
Discussion Starter #1
Just found this mount on a recently purchased 24 valve, never seen one like this in all my 164 years, is it a new type or a mount from another model car?
 

Attachments

·
Registered
Joined
·
338 Posts
Is that an old hydraulic unit that has almost completely disintegrated perhaps?
 

·
Registered
Joined
·
1,088 Posts
Discussion Starter #3
I don't think so, looking at it as it is now the rubber looks as though that is how it is meant to be, also looking at the photo it looks as though it does not even fit the place fully where it is meant to be, looks like a gap on one side, thinking it's from another model car, anyone else have information?
 

·
Premium Member
Joined
·
15,886 Posts
Some have used the similar Saab engine mount in that location, with minor mods.
 

·
Registered
Joined
·
1,088 Posts
Discussion Starter #5
No one recognises it, might remove it this evening and see if it has any stampings out of interest.
 

·
Registered
Joined
·
656 Posts
It is necessary to unscrew and look from all sides.
The original looks like this


I put this place back mount, without oil. Three years have passed - normal flight:smile2:. It should be a little change. Trim the bottom of the cup ( the red line ), so that it had the free wheeling.

 
1 - 8 of 8 Posts
Top