[John M]

Audiovox is the brand I installed. It came with a switch to mount on the dash or console. I though used an old 1/2 of an alfa window and hazard barrel switches in a 4 block to control mine.

Best Regards,
John M

 

[John M]

A couple of pictures with one installed. This unit taps into the coil and brake light for speed and disengangement signals respectively. Also if you hit the clutch and motor is without load...it'll kick out too. The unit is very easy to install. Your greatest challenge will be hooking up the throttle cable to your linkage. The unit comes with several provisions, but you'll likely have to get creative.

Best Regards,
John M

 

[John M]

OH....I bet you get a bunch of spam.

JCWhittney sells them online for around $150 or so.

Rostra is another manufacturer to consider.

Just make sure if you go with something other than the audiovox that the servo will fit in the car and that the unit will draw input from coil (-) or pulse generator.

Best Regards,
John M

 

[John M]

Eric:

My throttle bell crank is totally different from yours with the linkages. Mine is cable. What you need to accomplish is:

1. find a way to secure the cruises throttle cable so that it is aligned to pull the spring loaded bell crank.
2. secure the throttle cable to the bell crank so that it won't foul the gas pedal linkage yet allow the cruise servo to rotate the bell crank.

Here is a picture of my setup...but again will be different from yours.

Best Regards,
John M

 

[John M]

Thats the one Joe....the 100. No vacuum reservior required. Everything needed is included in the kit.

Best Regards,
John M