Alfa Romeo Forums banner
1 - 2 of 2 Posts

· Registered
57 Posts
Discussion Starter · #1 · (Edited)
I, in near future, I will be changing the timing belt and water pump on my Verde. While I'm at it, I would like to change a slightly leaky front crank seal. I have the Alfa tool for locking the flywheel to the bell housing. Does anybody have any good advice for me? Thanks!
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.