Alfa Romeo Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
404 Posts
Discussion Starter · #1 ·
Removed engine and trans today. Took out clutch but can't get fly wheel nuts lose. Nedd some help. Second should I bolt engine stand where trans was before.
 

·
Registered
Joined
·
404 Posts
Discussion Starter · #3 ·
1989 veloce fly wheel

Thanks for the diagram. does the engine stand bolt on to the motor mont studs. and is that how the diagram works.
 

·
Registered
Joined
·
404 Posts
Discussion Starter · #5 ·
1989 veloce fly wheel

Thanks I will try to get flywheel off. but photos are great. I just have to figure out how tohold the fly wheel
 

·
Registered
Joined
·
404 Posts
Discussion Starter · #9 ·
1989 veloce fly wheel

Thanks I'll get the bar and a pipe and give it a shot. I keep looking at the motor mount studs. It seems hard to believe that 3 studs and hold the entire engine.
 

·
Registered
Joined
·
404 Posts
Discussion Starter · #12 ·
1989 veloce fly wheel

Thanks for the help I just ordered the part. Trying to make a part to hold the engine in the stand then I should be ready to go.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top