Alfa Romeo Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,528 Posts
Discussion Starter #1
Made for Sprint GT 63-66 / GTC 64-66. Original arm rest pair used for molds-casted with strong&light 2k polyurethane resin (foam) -density 200kg/m3. Metal sleeve pair with reinforcement installed before casting-to replace original metal insert. All you need is to wrap it with same leather as inner door panel. Price 155euro,shipping worldwide.
 

Attachments

·
Registered
Joined
·
6,066 Posts
Hi Franjo,

I'm interested. We spoke about these arm rests a couple of years ago, if you remember. Would my original vinyl outer 'shells' fit perfectly on these new cores?

Thanks,

Alex.
 

·
Registered
Joined
·
1,528 Posts
Discussion Starter #3 (Edited)
Hi Alex
First you need to cut complete original vinil to install it, than the smallest imperfection (vinyl size) make it a challenge. Tiny foam to fill the gap in case of bigger vinyl or industrial fan carefully preheat to fit if you have shrinked vinyl. You need to fill your originals with polyurethane 2k foam but mold is needed to achive correct shape .
Regards
Franjo
 
1 - 3 of 3 Posts
Top