I purchased one from Alfaholics 3 years ago, but I don't see on their website today. I recall someone who purchased one after I did and there were quality issues. So not surprised to see it dropped. Mine fit nicely for bench assembly. Still not in car.
You need to examine the underside of the dash top. I believe the 1967 dash will have studs that are parallel to the top of the dash and pass thru the face of the metal dash. By 1969 the studs were installed at an angle. The top of the metal dash had a corresponding bend in it to accept the stud. I have heard that the aftermarket dash tops that could be found were mostly angled.
This is the face of a 1967 dash. The top studs pass thru the holes on top of the dash face.
This is the underside of a 67 dash top
This is the underside of my replacement dash top and the 1969 dash assembled
You don't have enough posts to receive a private message. 10 required I think.
Send me an email address and I will send pictures of my 1967 dash top I won't be using. Might be in better condition than what you have, but I doubt it. Mine is rough.
[email protected]