Alfa Romeo Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 30 Results
  1. Alfetta & GTV6 (1972-1986)
    I'm planning on completing rewiring my car this summer, and was wondering if anyone has done this and has any tips?
  2. Production Alfas (1992-2016) - [CA/USA Excluded]
    I have a 91 spider veloce, the airbag light is always on but the wiring diagram i have isnt helping much, anyone have a diagram that is for the airbag or includes it?
  3. GT (1963-1977)
    Hi there, this is my first post on this forum and I am going straight into the depths of electrics :) It is not that bad, I was just wondering if someone can confirm that reverse lights are active only when parking lights / main lights are turned on? In my case it is a 1973 2000 GTV in the...
  4. Spider - 105 & 115 Series (1966-1994)
    So, I replaced my water pump and spark plug leads, and for easiest access to the pump I removed the hood. However, it took me a bit to figure it out, and at some point I disconnected the wires at the very top of it, which at the time I figured them to be ground wires for some reason (threads I...
  5. Alfa Romeo Parts For Sale & Wanted
    Original wiring harness from an Alfa Romeo Giulietta Sprint Veloce. The harness was in a running and driving car prior to removal. Owner chose to replace the harness when the car was being repainted. Fuse block is not included with the harness. No signs of heat damage. Considering its age...
    $750 USD
  6. Alfetta & GTV6 (1972-1986)
    Hey all, Ive got a Wideband o2 sensor which I use on my car to ensure it is running in optimal conditions. The sensor needs to be run with power to heat the sensor for accurate reading and power the display. Ideally it needs to turn on after the car is started as the resulting water from...
  7. Spider - 105 & 115 Series (1966-1994)
    My Alfa was running great! Then after a short drive, it wouldn't restart after a normal shutdown. I hope I'm able to write this so it's understandable. It's been a couple of weeks of troubleshooting off and on. If you don't care to pick through this, I'll just say that I REALLY need a wiring...
  8. Alfetta & GTV6 (1972-1986)
    Hope someone can help me with this!? (US gtv6) When I use my high beam one side turns of and only one side works... I tried WD-40 on all connectors, all lamps work (switched out positions). ps. indicators are on normally but flash bright to normal when used. Turn position 1: only indicator...
  9. Spider - 105 & 115 Series (1966-1994)
    UPDATE - DIAGRAM RECEIVED. THANKS! Recently purchased an '89 Spider that is in reasonably nice condition but needs carpet and now an ignition switch. Prior to embarking on these repairs I purchased the available shop manual (reproduction) and CarDisc files. I am finding that neither of these...
  10. 164 & 168 (1991-1995)
    I am working on a fix for a tedious issue regarding all my warning lights being on. I found a thread with a solution to this problem involving going behind the cluster and adjusting connector B pin 7. However I cannot find a wiring diagram anywhere and I'm not to stoked on the idea of moving...
  11. Production Alfas (1992-2016) - [CA/USA Excluded]
    Hello, if anyone has access to fiat.com technical drawings, could you upload the schematic for "Headlamp alignment corrector", page number E3080? I have all other schematics (from italian service book), but I need correct wire colors/pin numbers for the sensor on front axle - it has rotted into...
  12. Electrical, Chassis & Lighting
    Well I know apparently papajam is the man to ask. Only problem is it looks like he hasn’t been seen around here in over a year. I’m really hoping to track down a color wiring diagram for a 73’ GTV Spica. I don’t know who may have contact info for papajam or maybe who’s taken the mantle from his...
  13. Spider - 105 & 115 Series (1966-1994)
    I’m new to this forum. I bought this beauty for my fiancé as an engagement present, and while we have the shop manual, there’s no key for the colors of the wires so we are at a loss to get this baby running. We can get her started but she poops out after about 10-15seconds. We are replacing the...
  14. Milano/75 (1985-1993)
    Hello fellow Alfisti! I finally took the decision to install an A/C to my 1.8 IE 75. I have purchased all necessary items that are required (Heater box, compressor, a/c controls etc.) but I'm missing the engine compartment's wiring harness. After studying the relevant electrical diagrams I...
  15. GT (1963-1977)
    My 1966 Sprint GT Veloce has four wires that run to the ash tray and cigarette lighter location on the gearbox tunnel. The wiring diagram indicates there's a lightbulb at that location. Larry at Alfa Parts Exchange wasn't aware of one, but I want to be sure. -Can anyone confirm there is a...
  16. Electrical, Chassis & Lighting
    Hello All, I have just rewired my Euro 74 Alfa Spider (Classic Alfa sourced wiring loom) which had a previously butchered loom using a 'Model 10524' wiring diagram and have been left with one rogue red live wire.. the wire is bunched together with two other wires (Blue/black and black and to...
  17. Alfa Romeo Parts For Sale & Wanted
    All or any of the parts listed below for a 1973 RHD Euro Spider. Fuel filler neck for carb tank (smaller 45mm version). Bulkhead grommet metal covers (wiring and steering). Short wiring between wiper, dash light and heater switches (switches to loom wiring). Ashtray inset (little tin ashtray)...
  18. Alfa Romeo Parts For Sale & Wanted
    I'm looking for a fuse panel for a 1966 Sprint GT Veloce. Any condition considered. Let me know what you have, and what you want for it. Thanks!
  19. Alfa Romeo Montreal
    BBers, As many know, I bought my Montreal with the engine bay in pieces and have been trying to put back the jigsaw puzzle without a finished reference. I do have a lot of good reference pictures for where things go in the engine bay, but no detailed pic of the starter solenoid wiring...
  20. Electrical, Chassis & Lighting
    If I were to remove all wiring and wanted to reinstall removing the interlock and it's harness, how would one do it? I know all about the recall modification bypass, but I want to totally get rid of it. I have a new ignition switch w/o #16 terminal as well. Does someone follow the '72 diagram...
1-20 of 30 Results
Top