Alfa Romeo Forums banner
seal
1-10 of 10 Results
  1. Spider - 105 & 115 Series (1966-1994)
    Hello gentlemen, I have a pinion seal leak as im having fluid drip back all over my diff and bottom sump plate. I want to remove the diff and axle tubes and grind/sand all the gunk and grime off them to get them looking close to brand new. I am looking to repaint the axle tubes as well. In...
  2. 164 & 168 (1991-1995)
    Hi, know we have discussed this a lot before but times move on and am still looking for a felt-lined 'seal' for the sunroof on a 1995 164, that costs less than a holiday. As many Volvo owners need the exact same seal there must be a market out there for someone to manufacture a decent batch of...
  3. Engine Repair, Diagnostics & Rebuilding
    Hello Rebuilding my 1600 on my Super. Should the rear crank seal be flush? It appears the old one was not by examining the coloring? (see pic below) I did put the oil slinger in behind regards Daron
  4. 164 & 168 (1991-1995)
    Hi, have been studying water ingress on an Alfa 164 for some time now. Currently looking at wet floorpans and the potential to ruin the front jacking points from the inside. Have also been doing this by endoscopic views inside the sills, via drilling holes but to begin with here is a basic, with...
  5. 164 & 168 (1991-1995)
    Hi, Sorry to be raising this issue again but, in the age of global sourcing, still find it amazing to not be able to obtain a proper sunroof 'seal' for the 164. A lot of Volvos of the era used these too and their owners are also searching for them - so what is going on? Where are these elusive...
  6. 164 & 168 (1991-1995)
    Hi, I know the external sunroof felt 'seal' availability issue has been covered before but am bringing it up again. Have tried the all rubber Alfa 75 seal, for the same size sunroof but possibly different sized hole as, for me at least, it does not work right. Too tight. Too binding - even...
  7. 164 & 168 (1991-1995)
    Hi, Got a new sunroof seal and my sunroof unit in my living room. Took the drive motor off so could slid it by hand - which worked fine until sliding it to the closed position. This has locked it in place. :-( I could re-attach the drive motor and power it open but is there an easier way, with a...
  8. Carburetors, Fuel Injection & Air Intake
    Hi all, Does anyone know of a stateside provided of the leather throttle shaft seals for the early DCOE models? Can these free bearings be replaced with sealed bearings?
  9. Giulietta & Giulia (1954-65)
    I am searching for photos of the correct door seals around the leading edge of the door. hoping to receive photos or any other additional information, or leads to previous posts regarding this subject in case it has been discussed before. Thanks, Peter
  10. Alfetta & GTV6 (1972-1986)
    Hello everyone, let me start out by saying that I've laid dormant for a while, because of a move to Florida, and back out to California again, a motorcycle accident, and some good old fashioned procrastination - but it's good to be back. Anyway, I have a '86 GTV6 from my father that has sat...
1-10 of 10 Results
Top