Yesterday i wanted to change the oil on my differential (non LSD). I have a 72 GT 1300 Junior. When i drained the oil on the magnetic plug i found a little piece of metal. I attache some photos. What could it be? Do i have to worry? Thanks.
I am looking for a 2 liter differential with axles.
A unit from a Spider or Berlina / GTV would be ideal.
Please send me a PM if you have one taking up needed space in your garage.
Oroville CA 95965-9267 , I prefer shipping.
I have a pinion seal leak as im having fluid drip back all over my diff and bottom sump plate. I want to remove the diff and axle tubes and grind/sand all the gunk and grime off them to get them looking close to brand new. I am looking to repaint the axle tubes as well. In...
I had what felt like worn wheel bearings on my 1972 2000 Berlina in the rear axle ( both sides) i could move the road wheel up down a little when jacked up it felt like play in the bearings and a knocking as you drove at low speed but no "whine" noise at high speed..
Today i have...
Two for sale.
Both have a 41 tooth ring gear, I don't know the teeth on the pinion gear.
Would rather not ship. Located in SE NH. I work in northern MA (near Glynn), and can bring them there.
Hello everyone, I hope everyone is having a fine day. i have a few questions that i cant find the answer to easily.
I own a 2007 sport-wagon with a 2.4 JTDM engine and automatic transmission. i had the transmission/ differential serviced about 5 months ago by Alfa here in Germany. last week...
Have a 74 spider. Just replaced diff pinion seal, but noticed that there is some kind of solidified rubber seal material in the gaps of the splined joint. Does anyone know what this is? I guess its there to prevent leak of gear oil, but I have not seen this discussed. Does it have to be...
I have a 1986 Alfa Romeo Spider that I am parting out. The car has been sitting for a few years, but before I started parting it out I made sure it runs. After replacing some vacuum hoses and cleaning some sensors it started right up, like an Alfa should.
Please contact me with all your parts...
Almost finished cleaning up my '78 Spider differential. I didn't touch the pinion bearings but I replaced the differential case/carrier bearings. Using the procedure in the shop manual for measuring the slop between the ring & pinion, I need to reduce the case side bearing shim thickness by...
I have a couple differentials I have swapped in an out of my ’78 Spider over the years as they start to get a little clunky when engaging the clutch. It is similar to a bad u-joint. If I grab the pinion flange I can rotate quite a bit without the wheels turning and if I twist it...
Repost more details: e-mail direct please, thank you
Engine turns freely and has compression
Transmission gears feel smooth
The oil is clean
Radiator is full and has no leaks
Fan is in good condition
Valve cover SOLD
The whole drivetrain is complete engine, transmission and...
The whole drivetrain is complete engine, transmission and diff.
Parting out. From valve cover to oil pan let me know what you need. Radiator, fan, dist. Cylinder Head, fuel inj. etc. Etc.
Car was siting for over 10 yrs. The oil and inside looks clean but do not know the condition. Thats why...