Alfa Romeo Forums banner

carburetors

  1. For Sale Dellorto DHLA40 carbs. Fully rebuilt, matching pair.

    Alfa Romeo Parts For Sale & Wanted
    Twin Dellorto DHLA40-G carburettors, fully rebuilt and in excellent condition. Professionally wetblasted on the Vixen Aquablast 915 (internal and external), ultrasonically cleaned and reassembled using only original Dellorto parts and Dellorto service kit. New mixture screws were installed and...
  2. dellorto 40 dhla intake leak ?

    Giulietta & Giulia (1954-65)
    Hi, I have a 1960 spider veloce with dellorto 40 dhla carbs. The engine was reluctant to start, had very poor progression and needed to be gunned quite a bit. I traced the problem to the acceleration pumps, took off the carbs and got the pumps to work properly (checked everything else as...
  3. Aluminum mounts in the States

    Carburetors, Fuel Injection & Air Intake
    Hello everyone, I'm in the process of rebuilding my 40DCOE webers for a Giulia GT Junior 1300. The rubber mounts are completely shot and therefore I would like to replace them with the long version of the solid aluminum mounts (for increased torque). I'm in California and have not been able to...
  4. weber rebuilding 76 spider southeast ?

    Spider - 105 & 115 Series (1966-1994)
    Looking to find a quick/economical /quality carb rebuilder for my car . I would like to ship out the carbs and have them fixed by a pro . We have some work to do as far as cleaning out old fuel and , blow out lines ect. Just was wondering if anyone has any history with anyone maybe in...
  5. Dellorto DHLA 40C vs. 40H

    Carburetors, Fuel Injection & Air Intake
    Greetings, I just tried to have the Dellorto DHLA 40H carbs in my Alfetta GTV2000L properly calibrated and this resulted in one adjusting screw being utterly destroyed; it was stuck at almost the bottommost point of the thread and it was quite impossible to move it. That carb (rear) is as good...
  6. Weber 40 DCOE rebulid questions.

    Carburetors, Fuel Injection & Air Intake
    Well, I disassembled the webers for servicing and cleaning.:) 1. Where should I buy the rebuild kit? 2. The choke assembly screen is clogged with black soot and slightly bent. 3. I am going to make an anti-slosh plate. 4. I could not detach the hexagonal bolt for the fuel filter gauze...
  7. 1965 101 Spider Veloce Weber removal..

    Carburetors, Fuel Injection & Air Intake
    We're trying to remove the webers on this 101 and have encountered an issue. After dismantling most nuts I realized that the passenger side fender inside the engine bay is blocking it from being removed. The studs holding the webers in place pert-rude about 1/4 inch, There is not enough...
Top