I am rebuilding my cylinder head and looking for suggestions about the cams and valve clearances for a street car. It has been daily driver for 35 years and still going strong! If I say how many miles are on it no one will believe me. I am lucky enough to live close to APE and Larry Dickman has...

Looking to get a Giulietta Veloce 1300 Cylinder Head - Pair of Cams (good used condition is fine). If you have a couple for sale please give me a call 805-241-0250.

Unfortunately I have to sell some spares to make some restoration budget available for my beloved Sprint. For the Giulietta 750 / 1300 engine: set of camshafts. It has the circle/cross marking, according to the manual, timings are different from the Normale. I guess ' between' normal and...

I recently got a new head for my 82 spider (old one cracked) and the when I installed the cams there was no gap between the lobes and the buckets. The cams, buckets, and tappets that I used were from the old head and now im worried that my cams might not fit this head or something. The new...

Hi everyone! I have these cams, they are track cams, fitted in a 1972 2000 gtv, with these specs: PROFILO: 120.314 SAS 11.9 IMPIEGO: lift intake 12.05 exhaust 12.05 work degrees clearance int ex 0,20 0,25 0,30 0,35 0,40 314° 0,45 0,50 306°...

Hi Everyone, I need help identifying a set of cams for a 2.0 nord engine. I know they come from Italy and are not standard as seen in the picture. They were sold to me as performance cams. Any ideas? Markings are numbered "03200". I am not a mechanic but have some knowledge but do not know...

I'm looking for the below parts: - Giulietta 1300CC Block: AR00120 - Front Timing Cover for 105 1300 Junior - 1300 105 Cylinder Head - 1 set of 2.0 Alfa Romeo Cams - Regrind - Giulietta 101 1300 Lower Transmission Metal Support - Giulietta Spider Side Door Glass - Giulietta Drive Shaft for a...

Looking for 1965 Spider Veloce Original Cams Please direct message me if you have them and how much it would be for shipping to Southern Califronia. Best, Bruno

Hi everyone, I'm trying to get my spider in tune for this spring (in MN, the spring started last week) and after a winter of working on other systems, its all coming together. Unfortunately, I'm having some pretty consistent popping from my webers. I know, I know.. read up on the subject first...

Folks, I'm working on a 74 GTV and like many examples, I'm finding a mix of parts from different cars. A previous owner did a weber conversion (40 DCOE 72's) with what looks like a 1600 intake manifold. It also has intake and exhaust cams that I believe are from a stock 1300 or 1600. Not sure...

Hi Does anyone know how much it is safe to flycut valve reliefs in standard 2l twinspark pistons? I want new cams without the added cost of new pistons. Any help appreciated

I recently took apart the 1300 engine that came out of my 61 Sprint and the cams on it have the numbers 76 19 101 on them and was wondering if anybody could tell me anything about them (size, if they're correct, anything else). All help will be greatly appreciated. Thanks in advance! -Matt