Alfa Romeo Forums banner

2l

  1. 155 / 164 crank in 2L Nord case: possible?

    Engine Repair, Diagnostics & Rebuilding
    Hallo everybody, I took a look around in the forum but the searching engine did not allow me finding the infos I need. The question is very simple: I'd like to install a 164 Super/155 90mm crankshaft in a 2L GTV (115 series), does it need any other modification than shorter rods or pistons? Just...
  2. Oil drilled Nord 2L engine: grooved bearings needed

    Engine Repair, Diagnostics & Rebuilding
    Hallo everybody, I've read that the subject has been discussed a few times in the past, but now I'm looking for informations about where I can find a set of main bearings for my 2L, wich had the famous #2 and 4 bearings drlilled for direct oil feed. Main suppliers like IAP seems to have only...
  3. 1600 cams on a 2L?

    GT (1963-1977)
    Folks, I'm working on a 74 GTV and like many examples, I'm finding a mix of parts from different cars. A previous owner did a weber conversion (40 DCOE 72's) with what looks like a 1600 intake manifold. It also has intake and exhaust cams that I believe are from a stock 1300 or 1600. Not sure...
  4. Wanted Good used set of std Borgo 84mm pistons

    Alfa Romeo Parts For Sale & Wanted
    Looking for a good used, or new, set of Borgo 84mm pistons (9 to 1 STD or 10 to 1 Mono). Thanks
  5. converting to 2l drive train

    GT (1963-1977)
    Hello All; I have a 66 sprint gt with a 2l drive train. It has the original drive shaft. I would like to convert to the later style with the improved center support bushing. Is this a simple bolt up, or is it more involved? thanks, as always, for your help. marc
Top