Alfa Romeo Forums banner

164

  1. For Sale 1995 164 L/S with A/T project for sale

    Alfa Romeo Cars For Sale & Wanted
    Good clean car with 130K miles(but with a salvage title) suddenly started running rough. Last timing belt about 12 years ago. I don't have time to work on it. Recent suspension and alignment work, clean interior, very good mechanically. I don't have the time to work on it. Located North...
  2. For Sale 91 Alfa romero 164L no sunroof

    Alfa Romeo Cars For Sale & Wanted
    Gray has 112k miles ready for a better home, we just dont have the time to mess with it. It is not running, it turns over and we thought it was the fuel pump (however it is not) I suspect its the timing belt sensor that went out on it but honestly just dont wanna mess with it. I talked to my...
  3. 164 v6 24v 1993

    New Members Introductions - Please Read
    Hi. The vehicle has only 132.000 km on the clock. It has not had a startup for the last 15 years. Now is the time. The petrol pump is replaced. wirering to the pump directly from battery because of a dead immobilizer. Pin 81 on the ECU becomes direct 12 v from battery (again dead immobilizer)...
  4. FS V6 Hydraulic Timing Belt Tensioner Rebuild Kit OEM 60777065

    Alfa Romeo Parts For Sale & Wanted
    Posted on eBay, 70$ shipped to USA. https://www.ebay.com/itm/Alfa-Romeo-V6-Hydraulic-Belt-Tensioner-Rebuild-Kit-GTV6-Milano-75-164-60777065/202825782284
  5. FS 164 K&N Air Filter 33-2645

    Alfa Romeo Parts For Sale & Wanted
    Posted on eBay, 50$ shipped to USA. https://www.ebay.com/itm/Alfa-Romeo-164-12V-24V-V6-K-N-Air-Filter-33-2645-71736138-60510292/202825781021
  6. 164 brake balancer

    164 & 168 (1991-1995)
    Hi, Just dropped a new brake balancer cylinder into my replacement rear subframe and pressure on the arm shows no visible movement of the cylinder. Is this normal? I took the cylinder out again and took off the detachable end part and applied a G-clamp to put pressure on one of the two...
  7. 164 rear bolt cutting

    164 & 168 (1991-1995)
    Hi, on-going topic, the long rear suspension bolts. One bolt I couldn't remove so removed the rear hub with strut and an arm attached. Angle ground the arm off, pausing to check heat transfer levels. The angle ground the strut off and the removed remaing exposed segements of the bolt. Despite...
  8. merovingion

    New Members Introductions - Please Read
    Hi folks, merovingion here to discover and share alfa news parts and purchases . I have need to sell alfa 164 parts and look for parts and purchases.
  9. Buying Alfa Romeo 164

    164 & 168 (1991-1995)
    Hello fellow members. I owned a Alfa Romeo 164L back in the 1990's and loved the car. I am thinking of buying another 164 on the used car market. I am trying to get advice from fellow owners as to anything I should be aware of or stay away from regarding years available, service and parts...
  10. 164 rear long bolt removal

    164 & 168 (1991-1995)
    Hi, Had this idea for removing these long bolts a while ago and today finally put it to the test. We are talking the 200mm M10 bolts that run through the bottom of the rear dampers and lateral arms - the ones that tend to sieze solid. The technique was simply as follows: While the car was jacked...
  11. 164 brake balancer bar plastic

    164 & 168 (1991-1995)
    Hi, Does anyone know a source or at least the part numbers for the two plastic spacers that go on a 164 brake balancer bar where it mounts to the rear subframe?
  12. 164 front end clonk

    164 & 168 (1991-1995)
    Hi, Have been having a clonk from the front end of a 1995 24v 3.0 164, UK spec. It mostly happened on steering inputs but not always. No play in front suspension bushes and even changed the engine mounts - were shot anyway. Think narrowed it down to the front strut lower bearing so took the...
  13. 164 sill construction and access

    164 & 168 (1991-1995)
    Hi, After having a couple of jacking points welded up, one front one rear, have been trying to coat the welds from behind by pumping/spraying anti-corrosion stuff in - without much success. For the rear took out the side carpet in the boot and the sound proofing piece of sponge, fitted into...
  14. 164 brake balance plate

    164 & 168 (1991-1995)
    Hi, Have taken the brake balance stuff (technical term) off a series 2 164 rear subframe and noticed the plate used to transfer load to the rear balance bar is plastic. Aged and worn in the case of the one taken off. Looking to make a new one, quite possibly from a block of nylon 6 or 6/6...
  15. For Sale Alfa romeo 164s sport front seats

    Alfa Romeo Parts For Sale & Wanted
    Alfa Romeo 164S Fronts Seats. Always intended to install these into my Saab 9000 - same platform. Compete wire harness with control module and all switches. Overall good shape for their age and rarity - could use some dye to make them perfect. Asking $400 - picked up. Located in LANSDALE, PA...
  16. 164 3.0 24v thermostat alternatives

    164 & 168 (1991-1995)
    Hi, need to source a thermostat for a 1994 164 3.0 24v manual. Some indications are the GTV or 164 12V versions will fit but confused as to whether I should be looking for just the insert or the top housing with insert in place. Have gone through the sheered bolt issue the last time it was...
  17. Alfa 164 V6 main engine mount

    164 & 168 (1991-1995)
    Hi, Have a new main engine mount to put on the car and unsure how. Have heard partially lowering the front subframe while supporting the engine is the way to do it. Tried undoing the nut (engine load still on) on top of the mount and couldn't turn it. Has anyone tried undoing one of these and...
  18. 164 sunroof seal again

    164 & 168 (1991-1995)
    Hi, Sorry to be raising this issue again but, in the age of global sourcing, still find it amazing to not be able to obtain a proper sunroof 'seal' for the 164. A lot of Volvos of the era used these too and their owners are also searching for them - so what is going on? Where are these elusive...
  19. making brake pipes

    164 & 168 (1991-1995)
    Hi, the old 164 steel brake pipes are looking exactly that. Am looking to by a brake pipe making tool to construct new ones but what size to buy for a 164?
  20. '95 164Q timing belt replacement needed? Last done 5k miles ago, but in 2011.

    164 & 168 (1991-1995)
    I just purchased a 1995 164Q online that I'll be picking up in a couple weeks. The car is in great shape and I plan on driving it home, which will be about 1,000 miles. The gentleman I purchased it from has offered to take it to a shop if I need to have the timing belt replaced before I drive it...
Top