Alfa Romeo Bulletin Board & Forums - Search Results
Advanced Search
Showing results 1 to 25 of 76
Search took 0.01 seconds.
Search: Posts Made By: rob3375
Forum: Limited Production (1960-1977)   08-19-2015, 03:06 AM
Replies: 7
Views: 1,727
Posted By rob3375
Hi just looking at this thread. If your car is a...

Hi just looking at this thread. If your car is a 1600 junior zagato it may have the screw type cap. The fuel tank on the 1600 is not the same as that of the 1300 junior zagato and is on the rear left...
Forum: Alfa Romeo Montreal   05-20-2015, 09:07 AM
Replies: 9
Views: 2,020
Posted By rob3375
Exclamation Steering box strengthening kit installation

792066

Hi I just stumbled on a steering box thread showing pics of the steering box strengthening plate installation. The installation is NOT correct if I am looking at the second pic of three...
Forum: Alfa Romeo Montreal   02-13-2015, 04:35 AM
Replies: 9
Views: 2,020
Posted By rob3375
Hi Hann, hope you are Well. My problem was that...

Hi Hann, hope you are Well. My problem was that the email address did not work and was returned as failed delivery. I tried a couple of times. And yes I realise that a response to my email would...
Forum: Alfa Romeo Montreal   02-13-2015, 03:48 AM
Replies: 9
Views: 2,020
Posted By rob3375
Hi for some reason I am unable to contact Mario...

Hi for some reason I am unable to contact Mario using the email address provided?

Thanks in advance Rob
Forum: Alfa Romeo Montreal   11-14-2014, 02:05 AM
Replies: 17
Views: 2,221
Posted By rob3375
I totally agree with your comments, life is about...

I totally agree with your comments, life is about experiences good and bad. Hopefully more good ones than bad. I too use my Montreal at every opportunity and then when im too old, if my kids are...
Forum: Alfa Romeo Montreal   06-16-2014, 07:21 AM
Replies: 64
Views: 8,428
Posted By rob3375
Hi I think that the reason for water pump bearing...

Hi I think that the reason for water pump bearing failure is more to do with the set up of the driving chains and the forces they place on the bearing set up. The forward bearing is quite under...
Forum: Alfa Romeo Montreal   06-16-2014, 06:55 AM
Replies: 64
Views: 8,428
Posted By rob3375
I have just experienced a failure on my 4 pot ATE...

I have just experienced a failure on my 4 pot ATE BMW callipers. Having always replaced the fluid at regular intervals which requires bleeding I discovered a very spongy pedal over a period of time....
Forum: Alfa Romeo Montreal   05-07-2014, 04:41 AM
Replies: 11
Views: 2,414
Posted By rob3375
Im sure most Montreals had aircon so liitle need...

Im sure most Montreals had aircon so liitle need for a sunroof and besides why would you want to destroy that gem of a roof lining! For me the roof lining is one of its best interior features.
Forum: Alfa Romeo Montreal   05-07-2014, 04:28 AM
Replies: 24
Views: 2,815
Posted By rob3375
Front nose

Hi Phil, not sure if this reply is too late. You did contact me previous about a new front panel, which wasnt necessary in the end. I have since obtained and started to dismantle an absolute wreck...
Forum: Giulietta & Giulia (1954-65)   04-11-2014, 09:10 AM
Replies: 4
Views: 758
Posted By rob3375
Hi I am looking for the lower front valance, rear...

Hi I am looking for the lower front valance, rear valance and also outer sills. The lower rear sections of the front wings would be good also just forward of the doors. I am realistic with regard to...
Forum: Giulietta & Giulia (1954-65)   04-09-2014, 05:41 AM
Replies: 4
Views: 758
Posted By rob3375
SS Giulia panels

Hi, I am new to this section of the forum and would like to enquire if there is anyone fabricating panels for the 101 series Sprint special? It is the lower areas in particular.

Thanks in advance...
Forum: Alfa Romeo Montreal   04-08-2014, 01:40 PM
Replies: 9
Views: 1,318
Posted By rob3375
Sorry Don, forgot to take lead with me so...

Sorry Don, forgot to take lead with me so couldn't transfer pics from camera. Will do this tomorrow. Regards Rob
Forum: GT (1963-1977)   04-07-2014, 01:50 PM
Replies: 4
Views: 1,296
Posted By rob3375
Hi thanks for the pics. This has made it easier...

Hi thanks for the pics. This has made it easier to decide on correct spec.

Thanks Rob
Forum: GT (1963-1977)   04-05-2014, 03:09 PM
Replies: 4
Views: 1,296
Posted By rob3375
530 engine specification

Hi first my apologies with regard to my posting about headrest piping which appeared in the paint thread. For some reason I missed the new thread button.

As my car was retro fitted with a larger...
Forum: Alfa Romeo Montreal   04-05-2014, 02:45 PM
Replies: 9
Views: 1,318
Posted By rob3375
Hi, I have some cam covers. They have been...

Hi, I have some cam covers. They have been finished in black crinkle Finnish for my rebuilt engine, but I decided to paint my existing covers and go for a grey Finnish closer to original. The...
Forum: Limited Production (1960-1977)   04-02-2014, 01:59 AM
Replies: 26
Views: 5,829
Posted By rob3375
1300 Junior Z headrests

Hi, I have had to remove the cover on one of my headrests to make a repair to the metal rod which has broken allowing the headrest to fall from its upper position. I would like to ask if anyone can...
Forum: Alfa Romeo Montreal   03-05-2014, 01:33 PM
Replies: 0
Views: 776
Posted By rob3375
New rubber bonnet stops

Hi not sure if alfabb forum members follow the uk montreal yahoo forum? Just letting you know that I have produced an exact copy of the original rubber bonnet stops as well as the bonnet catch...
Forum: Alfa Romeo Montreal   03-05-2014, 01:11 PM
Replies: 1,055
Views: 145,739
Posted By rob3375
Hi sorry for some reason my post on suspension...

Hi sorry for some reason my post on suspension talk is linked to the wrong thread.
Forum: Alfa Romeo Montreal   03-05-2014, 01:08 PM
Replies: 1,055
Views: 145,739
Posted By rob3375
Hi just spent ages writing a reply and it timed...

Hi just spent ages writing a reply and it timed out so my take on handling kits are any replacement of 40 year old components is going to make a big difference. A uk Alfa specialist corner weighted...
Forum: Alfa Romeo Montreal   02-13-2014, 01:12 PM
Replies: 7
Views: 2,203
Posted By rob3375
Hi I purchased a set of these clamps. There were...

Hi I purchased a set of these clamps. There were a few sizes missing and quite a few surplus clips left over. That said it was good value compared to individual clips. I can confirm that they are...
Forum: Alfa Romeo Parts For Sale & Wanted   02-10-2014, 11:25 AM
Replies: 2
Views: 438
Posted By rob3375
Hi are the Lenses Carello or aftermarket?

Hi are the Lenses Carello or aftermarket?
Forum: Alfa Romeo Montreal   01-31-2014, 12:44 PM
Replies: 55
Views: 3,255
Posted By rob3375
Hi, I can check this also as I have the kmh...

Hi, I can check this also as I have the kmh speedo I removed. I will say though as a tall driver I do find the instrument visibility useless even during daylight. Another reason for using a satnav. ...
Forum: Shop Talk   01-31-2014, 12:47 AM
Replies: 19
Views: 4,266
Posted By rob3375
Hi Just stumbled across this post. I am in the...

Hi Just stumbled across this post. I am in the Uk and still use a 1960s/70s Bradbury 4 post lift which also has a beam system which allows you to position them in the desired place under the car and...
Forum: Alfa Romeo Montreal   01-31-2014, 12:25 AM
Replies: 55
Views: 3,255
Posted By rob3375
Monty MPH speedo

Hi I have attached a pic of my MPH speedo on my 71 LHD Montreal.
Forum: Alfa Romeo Montreal   01-29-2014, 12:56 PM
Replies: 55
Views: 3,255
Posted By rob3375
Hi I am a Brit Monty owner. The original speedo...

Hi I am a Brit Monty owner. The original speedo calibration is very accurate. I fitted a mph speedo to my lhd car. However nighttime driving is hopeless. Now with all the cameras and speed traps I...
Showing results 1 to 25 of 76

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome