Alfa Romeo Bulletin Board & Forums - Search Results
Advanced Search
Showing results 1 to 25 of 500
Search took 0.11 seconds.
Search: Posts Made By: kuni123456
Forum: Giulia (2017-current)   10-16-2019, 10:55 PM
Replies: 10
Views: 313
Posted By kuni123456
The State of California requires smog check for...

The State of California requires smog check for built after 1975 especially for Southern California. A new car does not need a smog test until it is six years old.
Forum: Engine Management   10-16-2019, 04:25 PM
Replies: 32
Views: 1,317
Posted By kuni123456
I just received one more ignition module attached...

I just received one more ignition module attached to a Bosch coil. I was able to start the Milano with the latest module and coil. I now have three modules and three Bosch coils. I had only one...
Forum: Giulietta & Giulia (1954-65)   10-16-2019, 03:27 PM
Replies: 29
  Tires
Views: 1,737
Posted By kuni123456
I used Pirelli CN36 175 70 VR15 tires on my 101...

I used Pirelli CN36 175 70 VR15 tires on my 101 Sprint Veloce. I see ads for Pirelli 165 VR15 tires and would recommend them over the original Pirelli Cinturato 155 R15 tires. I used the original 4.5...
Forum: Alfetta & GTV6 (1972-1986)   10-14-2019, 08:21 PM
Replies: 22
Views: 7,689
Posted By kuni123456
I belong to AAA and get 3 or 4 tows up to 100...

I belong to AAA and get 3 or 4 tows up to 100 miles. I recently had to be towed nearly 50 miles when my Milano broke down on the freeway. The towing rate in Los Angeles is $9 per mile. I had to be...
Forum: Alfetta & GTV6 (1972-1986)   10-14-2019, 05:29 PM
Replies: 22
Views: 7,689
Posted By kuni123456
I would recommend to replace the fuel pump hose...

I would recommend to replace the fuel pump hose and use the high pressure hose. I had a small fuel hose leak for several years (Milano Verde) and finally was able to locate the leak which was in...
Forum: Alfa Romeo Parts For Sale & Wanted   10-13-2019, 03:42 PM
Replies: 0
Views: 83
Posted By kuni123456
Giulietta Steering Wheel Puller, custom made

For Sale Giulietta steering wheel puller, custom made by Randy Pene, $300 plus shipping
Forum: Engine Management   10-12-2019, 07:43 PM
Replies: 32
Views: 1,317
Posted By kuni123456
I have purchased many Milano parts because I knew...

I have purchased many Milano parts because I knew years ago that you needed them in order to drive the cars. I buy new parts as much as possible and buy used parts from Alfa Parts Exchange, ABB, eBay...
Forum: Alfa Romeo Parts For Sale & Wanted   10-12-2019, 05:21 PM
Replies: 0
Views: 85
Posted By kuni123456
Giulietta Sprint Gas Tank

For sale Giulietta Sprint Normale gas tank, in good condition but needs to be cleaned before using, $200 plus shipping from Los Angeles
Forum: Engine Management   10-12-2019, 05:14 PM
Replies: 32
Views: 1,317
Posted By kuni123456
I just received a Bosch coil and ignition module...

I just received a Bosch coil and ignition module Bosch 0 227 100 111 from Israel. I installed it in the car and it started and ran great. I now have two extra Bosch coils and two extra Bosch 0 227...
Forum: Car Restoration   10-12-2019, 04:04 PM
Replies: 170
Views: 37,450
Posted By kuni123456
I am going to change oil and filter because the...

I am going to change oil and filter because the engine was rebuilt. I just bought a tube wrench and tube wrench rod to complete my original tool bag.
Forum: 164 & 168 (1991-1995)   10-11-2019, 05:39 PM
Replies: 14,389
Views: 869,580
Posted By kuni123456
I started working on 1957 Sprint restoration and...

I started working on 1957 Sprint restoration and changed oil on my friend's 1948 Bentley Mark VI. The cost of rebuilding a Bentley or Rolls-Royce engine is much more than rebuilding an Alfa Romeo...
Forum: Giulietta & Giulia (1954-65)   10-11-2019, 05:32 PM
Replies: 43
Views: 5,248
Posted By kuni123456
I like your story and have my father's 1961...

I like your story and have my father's 1961 Sprint Veloce which has been in our family since 1961.
Forum: Alfa Romeo Parts For Sale & Wanted   10-10-2019, 03:59 PM
Replies: 9
Views: 312
Posted By kuni123456
The manifold is a 101 1300.

The manifold is a 101 1300.
Forum: Spider - 105 & 115 Series (1966-1994)   10-09-2019, 01:35 PM
Replies: 10
Views: 197
Posted By kuni123456
I like using the Reinz head gaskets and think...

I like using the Reinz head gaskets and think that you have leaking oil rings in the head gasket. I had problems with the original V6 head gasket leakings oil into the coolant but, never had any oil...
Forum: Alfa Romeo Parts For Sale & Wanted   10-06-2019, 09:33 PM
Replies: 13
Views: 316
Posted By kuni123456
I have a 105 Giulia Super engine and it is one...

I have a 105 Giulia Super engine and it is one inch shorter than the 1750 engine. The difference is the block height. The crate I made for the 1750 engine should fit. The breather was removed from...
Forum: Alfa Romeo Parts For Sale & Wanted   10-06-2019, 03:39 PM
Replies: 13
Views: 316
Posted By kuni123456
I went to Home Depot and they cut the plywood to...

I went to Home Depot and they cut the plywood to the dimensions and was able to use 2 1/2" wood screws to put the box together. Good luck
Forum: Alfa Romeo Parts For Sale & Wanted   10-06-2019, 02:34 PM
Replies: 13
Views: 316
Posted By kuni123456
The shipping cost using a freight company is not...

The shipping cost using a freight company is not that expensive but, I do not want to send a bare engine on a pallet without protection. The engines (102 2000 Spider engine, 750 Veloce engine, 1750...
Forum: Engine Management   10-06-2019, 02:29 PM
Replies: 32
Views: 1,317
Posted By kuni123456
I received two used Bosch 0 227 100 111 ignition...

I received two used Bosch 0 227 100 111 ignition modules from Germany and both modules work. I also received another used Bosch 0 227 100 111 module that does not work. I have not received a...
Forum: Alfa Romeo Parts For Sale & Wanted   10-06-2019, 02:12 PM
Replies: 13
Views: 316
Posted By kuni123456
I just built a crate for a 1750 engine. I found a...

I just built a crate for a 1750 engine. I found a wooden pallet and used 3/4 plywood (2 - 4x8 sheets) and 2x4 to construct the crate. The wood was purchased from Home Depot for $85 including a hold...
Forum: Milano/75 (1985-1993)   10-05-2019, 09:01 PM
Replies: 5
Views: 1,056
Posted By kuni123456
I have been having problems with cold starting...

I have been having problems with cold starting with my Milano Verde. I will measure the temperature sensor and compare it with my other Milano Silver temperature sensor. If the sensor measures the...
Forum: Engine Repair, Diagnostics & Rebuilding   10-03-2019, 08:20 AM
Replies: 111
Views: 5,007
Posted By kuni123456
I see that the new pump gear has worn and could...

I see that the new pump gear has worn and could be due to incorrect machining or using different material than the original bronze gear. I look at both gears and the gear profiles are not the same....
Forum: Alfa Romeo Parts For Sale & Wanted   10-02-2019, 10:34 PM
Replies: 7
Views: 236
Posted By kuni123456
I have three Bosch generators. I know that one is...

I have three Bosch generators. I know that one is rebuilt and two are unknown. The two generators turn and can test them tomorrow.
Forum: Engine Management   10-02-2019, 10:30 PM
Replies: 32
Views: 1,317
Posted By kuni123456
I appreciate your help and will see if the four...

I appreciate your help and will see if the four used modules I ordered from three different sources fix my problem. I have one used Bosch 0 227 100 111 that does not work in either Milano. I call...
Forum: Engine Management   10-02-2019, 06:49 PM
Replies: 32
Views: 1,317
Posted By kuni123456
I was told the Bosch 0 227 100 123 was a...

I was told the Bosch 0 227 100 123 was a replacement for Bosch 0 227 100 111 and it should work but, neither Milano will run with this new Bosch module. The 1987 Milano Silver and 1988 Milano Verde...
Forum: Engine Management   10-02-2019, 09:36 AM
Replies: 32
Views: 1,317
Posted By kuni123456
I bought the unit from a BMW independent repair...

I bought the unit from a BMW independent repair shop and have told that it may work or may not work. I installed the module in two Milanos and had the same result. I purchased three used modules and...
Showing results 1 to 25 of 500

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome