Alfa Romeo Bulletin Board & Forums - Reply to Topic
Thread: Giulia spider Axle wrap Reply to Thread
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Alfa Romeo Bulletin Board & Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
06-16-2019 09:26 AM
Gubi Quick test for the reaction triangle. Drive down a street slowly, take your hands off the wheel, and get on and off the throttle. If you can steer the car left and right with the throttle, your bushes are probably bad.
06-16-2019 08:54 AM
aamatruda Thanks Chris,

I have a new ball joint on order as that is the only item that hasn't been replaced. I have attempted to remove the triangle the the rear axle in place but cannot drive out the tapered pin.
06-15-2019 10:08 PM
pescara Hi,

I will check the state of the ball joint, and the bushes, on the triangle reaction.

But it seems to come from a bad adjustment of the gap between the teeth, in the rear axle... (?)

06-11-2019 08:44 PM
Giulia spider Axle wrap

I have been trying to figure out the cause of this jerking I get under hard acceleration and deceleration. Setting up the car on a lift and lowering the rear axle on jack stands, I could video the drive train and look for where this oscillation originates. Setting the emergency brake and slipping the clutch into third would simulate the condition and I captured it in the following link. The rear axle pinion bounces up and down which looks like a condition in leaf sprung axles called "axle wrap" . It shouldn't happen with our cars unless some link is bad. Considering all the silent blocks are fairly new, I have been stumped. I suspect the reaction triangle ball joint could be worn only because I don't remember the condition when I rebuilt the rear suspension and have run out of other ideas. The only non-stock item are the Centerline stiffer rear springs which should be a plus although they are a shorter springs.

I thought the vintage racing folks may have run into this before. Any ideas?

Best Regards,

Andy Amatruda

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

For the best viewing experience please update your browser to Google Chrome