Alfa Romeo Forums banner

2600 Engine Parts

For Sale 
2K views 9 replies 5 participants last post by  Redmerlin 
#1 · (Edited)
Engine block with refitted crankshaft new bearings $ 700.00 OBO

Head compete with Cams ( with but not installed new IN Ex
valves and seats $ 700.00 OBO

Front timing cover $ 75.00

Crank shaft with new bearings $ 250.00 OBO

Valve cover with new gasket $ 125.00

My project is in the finishing stages. Part I accumulated for the build
and didn't use so off they go to help some one finish there project

All prices negotiable freight on buyer
 
#4 ·
#5 ·
On my last engine build I found a NOS block and gave it with a timing cover to the engine builder

Comments from engine builder

"Regarding problems in fitting parts together, the first one was that the new block did not have a matching front cover. That supplied was not correctly lined up, being short top and bottom by about 5 thou and the timing gear bosses were about 1mm out of line. This required some clever machining to the boss in the block and an offset bush, plus milling the top face to match which resulted in having to machine the top face of six liners to produce the required 2.5 thou of protrusion. The next problem was that the front cover was Mk2 with no oil pressure relief valve and the new old stock pump was Mk1 without one either. Fortunately I spotted this and a Mk2 pump was found and the best bits of two made into one. "

This gentlemen is a real engine builder who has worked on alfa engines for over 30 years . I i had just assembled it as supplied it would not have run for long
 
You have insufficient privileges to reply here.
Top