Alfa Romeo Bulletin Board & Forums - View Single Post - Rear axle oil seal groove
View Single Post
post #5 of (permalink) Old 04-01-2019, 09:49 AM Thread Starter
goats
Registered User
 
goats's Avatar
 
Join Date: Jul 2006
Location: san diego CA
Posts: 5,075
oh yeah, new bearings for sure. Heres the draft plan
Get 34mm speedisleeve and a tube of ultra grey
assemble new bearing onto axle
assemble bearing retainer onto axle -- using 1 1/2 inch ID iron pipe driver
machine up a tight fit collar for speedisleeve and use that to drive it down into position, with ultra gray adhesive

Sound reasonable? Since the gap between axle OD and speedi ID is pretty small, flexible adhesive like ultragray should be fine (theres only radial slip load and its tiny I expect)

seem OK?

74 GTV with 10548's and Ingram pump
71 Spider 1750 BOMBER ; 1995 LS 78K tight fast car
goats is offline  
 
 
For the best viewing experience please update your browser to Google Chrome