Alfa Romeo Bulletin Board & Forums - View Single Post - Rear axle oil seal groove
View Single Post
post #1 of (permalink) Old 03-31-2019, 09:41 PM Thread Starter
goats
Registered User
 
goats's Avatar
 
Join Date: Jul 2006
Location: san diego CA
Posts: 5,196
Rear axle oil seal groove

What alternatives to speediseal have you used? My axle has a groove from the oil seal ; normally a speedisleeve be fine. However, on the rear axle, the rear axle bearing is aft (outside) of the oil seal sealing surface. Which means, the bearing and retainer ring would have to go on first, then the speedisleeve. I don’t think the bearing and retainer will pass over the sleeve...

So ok for the first time. What happens when the bearing needs to be replaced after the speedisleeve is installed? Tear it off, machine off the adhesive used, and redo??

Alternative is weld up and machine the axle back to 34mm?

Thoughts? Thanks!

74 GTV with 10548's and Ingram pump
71 Spider 1750 BOMBER ; 1995 LS 78K tight fast car
goats is offline  
 
 
For the best viewing experience please update your browser to Google Chrome