Join Date: Jul 2006
Location: Galena, Illinois
Early driveshaft more info
Yes, that is exactly what I am looking for. Can you supply the following:
1) Length end to end
2) Diameter of bolt holes at the gearbox end ….. 10 mm or 12mm?
3) The removal fork on the gearbox end …. is it aluminum or caste iron? (see photo of two sample I have seen … is yours different?)
4) In that fork, is a bushing that matches the end of the gearbox …….. is the inside diameter 23 mm … so you have a screw on pawl on your tunnel case …. or is it 18 mm … so you have "machined pawl" on your tunnel case?
5) can you take a picture of the surface of the shaft that would contact the removable fork.
Thanks very much