Alfa Romeo Bulletin Board & Forums - View Single Post - S3 heater fan R/R & drain holes
View Single Post
post #16 of (permalink) Old 11-25-2013, 10:29 AM
SteveB2175
Registered User
 
SteveB2175's Avatar
 
Join Date: Jan 2012
Location: Cincinnati, Ohio
Posts: 264
Hmm, well I sure as heck don't have a fingers width of room, so that is some very good info you provided, thank you !!

If yours was tight with a fingers width of room, I doubt I could do mine with zero clearance

I'm just thinking out loud here, I obviously would look into this carefully before starting, but...

From the pictures I've seen it appears that the blower fan is what would prevent the bottom of the assembly from sliding out. In other words, if it weren't for the fan, the bottom would side horizontal w/o having to tilt it. in that event only a 1/16 th of an inch would be needed. So... what if one were to cut the plastic housing to allow clearance for the fan, then glue the piece back in after reassembly...

Like I said, just thinking here....

1988 Spider Graduate - "Black Beauty"
"When I see an Alfa Romeo go by, I tip my hat. " - Henry Ford 1939
SteveB2175 is offline  
 
 
For the best viewing experience please update your browser to Google Chrome