Bell housing to Engine bolt/stud

jimcra · #1 (**permalink**) 01-13-2007, 11:13 PM

For 74 GTV..Does anyone know the correct size bolt/stud used to attach the bell housing to the engine that is directly above the clutch slave cylinder? It seems to be about 3 1/2 inches long and maybe an 8M. Is it fine or course? 1.25 or 1.5? Is it a stud threaded on the bell housing side only? Is it a special type of bolt/stud? The hole is through and through, therefore is not broken off. Any suggestions?? Thanks in advance....

**papajam** · #2 (**permalink**) 01-14-2007, 05:50 AM

All four bellhousing studs are the same size; 8mm x 1.0mm x 70mm both ends threaded.

jimcra · #3 (**permalink**) 01-14-2007, 10:24 AM

Thanks again Papajam! You sure know your Alfa details. Thanks..

**papajam** · #4 (**permalink**) 01-14-2007, 10:51 AM

Having the Alfa parts book doesn't hurt either.