Alfa Romeo Forums banner

Rebuild on 164S

1K views 4 replies 5 participants last post by  MrT 
#1 ·
Hello all,

I'm currently rebuilding my 164S engine. I was hoping someone would know of a place to get new parts for the engine. New bearings, seals, water pump, thermostat, belts, etc. Any help would be appreciated.
 
#2 ·
All the normal parts places...Difatta Bros, International Auto, Centerline, Jason.

Some use Vick Auto Parts.

This would make a useful thread...Where do you buy from?
 
#4 · (Edited)
I wouldn't, but might I suggest you put list over on parts for sale list as WTS and then post a link to it over here on 164 forum.

If you mean rebuild parts list by all means go for it.
 
#5 ·
I'd have interpreted Sean's question as whether to post the list of parts which went into his recent rebuild, rather than the list of parts he had left-over and available for sale. Either might be correct, but if Sean meant providing a list of parts which went into his rebuild, more power to him.

My wife's rebuild involved:
new gasket set (lots of stuff there -- oil seals, etc)
new main bearings
new rod big-end bearings
new small-end rod bushings
piston rings and hone liners, liner O-rings (in gasket set)
Permatex anaerobic gasket maker (cigarette seal supplement)
valves to replace those bent by P.O.'s out-of-time condition
new timing belt and tensioner
new water pump
T-stat housing hoses to heads and oil heat exchanger
new serpentine belts and idler pulley
new reaction rod and shifter bushings (engine out, why not?)
examine half-shaft, steering, and strut boots for replacement
(consider whether to replace radiator or heater core now)

and now is the time for:
oil,
coolant,
power steering fluid,
transmission lube,
brake fluid flush
examine pads, discs, and e-brake cables

And I suspect I've left out some significant things.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top