General Forums
Alfa Romeo Production Models Forums
Alfa Romeo Technical Forums
Alfa Romeo Classifieds Forums
Vendor Member Section
Want to Grow Your Business? Learn more about becoming a Supporting or Premium Vendor
Regional Section
Latest Posts
-
Hi friends, Did a short test run today and the car overheated, fan did not turn on. This was an intermittent problem that was there for some time. Disconnected the 3-wire connector and did the following tests. Had a manual override switch to keep fan ON while doing the "sensor side" test...131 replies 5K views
-
I need a set of brass exhaust manifold nuts for my '88 spider. The 8mm X 1.0. They seem to be out of stock absolutely everywhere. Except for "Mr. Fiat." Who has them for $3 apiece. Is that normal? Does anyone know a good source (in USA)?5 replies 114 views
-
Need good working factory light weight starter for 131 tooth ring gear. Will buy two if available. Rj6 replies 179 views
-
Since my amazing neighbor/favorite Alfa mechanic is preparing to pack up and leave the DC metro area soon, it would seem I'm on my own to remove the driveshaft from my '87 Milano Gold and replace the flex couplings (a.k.a. giubos). Had hoped he could fit the job into his schedule before moving...13 replies 351 views
-
Hi all - I know this sounds incredibly obvious, but I can't adjust the headrests in my '91 S4 Spider up and down! They are about four inches up, and I can't raise, lower or remove them (which is really what I want to do!). I see that the "outside" headrest post has detents on the back side...2 replies 154 views