Brake Light/Tail Lights Grounds?

[Rookie ROX]

Quote:

Originally Posted by 75evo I think this is a problem with the early type circuit boards. AFAIK there are 2 types of rear tail light circuit board. The earlier ones (like the ones on my '87 Gold) tends to suffer from grounding problem and the plastic conecters tend to melt at one of the connectio points.

[AlfaVerde88]

Thanks!
Now that I know that there are two types and I would like to see a picture of the later version board.

The fix was not hard at all with a soldering iron and some wire. Gubi showed me the way and I did what worked best for me. The way I did it keeps the wires out of the way and I attached them to the back of the board so I knew they would still sit in flush and be easy to take off to change bulbs. The trunk latch as a ground was the closest, and best, choice I had after using an Ohm meter.